Changing Door Locks Do It Yourself

Changing the lock yourself examine the latch of the door to determine what brand of lock it is.

Changing door locks do it yourself.

Purchase a new lock. Replacing the lock on a front door. Then remove each side s door knob by pulling them away from the door. Installing the new lock is an.

Rekeying involves realigning the pins and springs in the inner workings of the lock in order to match the lock. Step 2 remove the screws from two halves of lock. Insert the pins and reassemble the lock dump out the old pins insert the new key and use tweezers or small needle nose pliers to match the new colored pins to. As stated above you need access to both sides of the door at the same time when changing locks.

Step 1 purchase a new lock. Step 3 install the new lock. Step 1 prop the door open. Use a phillips head screwdriver to unfasten the two or three screws located on the inside knob plate.

Purchase the same lock from a local hardware store. Everything should work without having to put new holes unless you change the style of your door knob. In apartment complexes this is now the most common way of changing locks on a door. Slide the outside parts of the.

Put the two pieces together and then screw in the door piece. Then screw in the new door knob piece and tighten it with your screwdriver. In some cases door latch plate mortises might need to be cut or enlarged. Open the door and.

Remove the old lock. Begin by removing the screws from the door knob on the interior side of your door. Door lock installation 1. Install your new lockset making sure that the keyed section is on the outside.

Before you begin make sure you have a new door lock set and a screwdriver or drill. Measure the back set of the door by measuring from the door latch to the middle of the door knob. You will want to find one that is keyed on only. Remove the old deadbolt.

Step 4 insert new tongue plate. Step 3 remove screws from tongue plate. Remove the screws from the old lock on the inside of the door. Chisel out any uneven recesses in the latch so that your new latch will fit perfectly.

Now put the door handle together in the opposite way that you took it apart. How to change a lock step 1. Go to the store and purchase a new lock. This allows you to pull the door.

Step 2 remove the old lock. You may also need to use a wire tool or a paper clip. Remove the two screws from the latch plate on the edge of the door and remove the latch from the opening. Once the new pins are in reverse the steps to reassemble the lock.